Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
166.137.141.204
In Reply to: RE: Morrow IC's posted by Medium Jim on February 09, 2012 at 12:42:29
Okay, I googled Jon Risch DIY and see that he says to use Belden wire that has been prepped. The only way to know exactly what Mike Morrow is doing would be to dissect his cable.
Again, the MA1 sounds good in my system and is very dynamic and transparent.
Jim
Music is the best thing you can do legally that doesn't require a medical prescription!
Follow Ups:
I was not talking about that Belden cable project but his 1" ribbon of 2 wires on a strip of tape, unless I am confusing him with someone else.
Satie:
Didn't see that one, I can tell you, it isn't wire on tape though and it is more than one run, it is two runs of wire. I haven't bought in to the notion that more wraps of wire for IC's is necessary or will sound any better. I'm probably wrong and in due time will upgrade and see, but right now, I'm liking what the entry level MA-1's are giving me.
Jim
Music is the best thing you can do legally that doesn't require a medical prescription!
More runs let you pass more deep bass, since you use a sub it is not important that you get minor attenuation of lower bass dynamics since you would just notch up your sub slightly.
I have never seen a Morrow cable opened up so I can't say with certainty.
Satie:
I did notice them to be a bit bass light at first, but that was when I had them running from the amps to the pre. I do like the dynamics and the subtitles that they flesh out.
Jim
Music is the best thing you can do legally that doesn't require a medical prescription!
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: