- RE: Which B7 for 6n6p linestage? - mqracing 09:11:56 04/23/09
(1)
- In Reply to: RE: Which B7 for 6n6p linestage? posted by bequerel on April 23, 2009 at 00:13:05
The 5K model has sufficient primary L in most cases that it should work well(i.e., provide an adequate load impedance) with a 6n6p tube.
If you want or need to burn some gain then you might look at a B7-8K
or a B7-10K.
In many preamp or line level apps--- the secondary is either very lightly loaded or not loaded at all (i.e., intentional loading). When this is the case it is the primary L that effectively provides the load impedance that the anode of the tube is looking into. The stated primary impedance under these conditions can be moreso viewed as an alternate way of stating the voltage ratio (i.e., turns ratio)--- and the user might be moreso governed in their selection of which "nominal" impedance is best by considering what they want or can do with their voltages--- how much step down do they want or need.
You still want to pay attention however to the MOL listed for each primary winding.
Hope this helps.
MSL
Builder of MagneQuest™ & Peerless™ transformers since 1989
- Great reply! - bequerel 23:27:53 04/23/09
(0)
- In Reply to: RE: Which B7 for 6n6p linestage? posted by mqracing on April 23, 2009 at 09:11:56
Thanks a lot Mike!
I am building a 12B4 linestage first with the B7 5Ks I bought from you some time ago. After that I am planning on a 6n6p for friend. Based on your reply, I think I would choose the B7 8K to burn more of the 20x amplification. I will get back to you when I am ready to order.
- Great reply! - bequerel 23:27:53 04/23/09
(0)
Post a Followup:
