• RE: I made unofficial datasheets...with measurements - mqracing 20:00:37 04/16/15 (3)
  In Reply to: RE: I made unofficial datasheets...with measurements posted by Bas Horneman on April 16, 2015 at 06:07:53

  Bas. Hello. Nice. Thanks.
  
  If you could update my address as follows;
  
  1936 E Clementine St
  Philadelphia, PA 119134
  
  and maybe put my email acrosound@aol.com
  
  Thanks again.
  
  MSL
  
  
  
  Builder of MagneQuest & Peerless transformers since 1989
  
  
  

  ---

  • RE: I made unofficial datasheets...with measurements - Bas Horneman 01:50:52 04/17/15 (2)
    In Reply to: RE: I made unofficial datasheets...with measurements posted by mqracing on April 16, 2015 at 20:00:37

    Will do Mike!
    To infinity and beyond!!!
    
    

    ---

    • Done....nt - Bas Horneman 01:27:26 04/22/15 (1)
      In Reply to: RE: I made unofficial datasheets...with measurements posted by Bas Horneman on April 17, 2015 at 01:50:52

      .
      To infinity and beyond!!!
      
      

      ---

      • Thank you Bas! - mqracing 09:46:16 04/27/15 (0)
        In Reply to: RE: Done....nt posted by Bas Horneman on April 22, 2015 at 01:27:26

        nt
        
        
        
        Builder of MagneQuest & Peerless transformers since 1989
        
        
        

        ---
• RE: I made unofficial datasheets...with measurements - petercapo 08:34:10 04/16/15 (2)
  In Reply to: RE: I made unofficial datasheets...with measurements posted by Bas Horneman on April 16, 2015 at 06:07:53

  Thanks for posting that. Based upon those measurements, it does seem like it is larger than my dynakitparts Z-565.
  
  Thanks.
  Peter
  

  ---

  • RE: I made unofficial datasheets...with measurements - mqracing 20:02:28 04/16/15 (1)
    In Reply to: RE: I made unofficial datasheets...with measurements posted by petercapo on April 16, 2015 at 08:34:10

    what you might consider doing is using your existing bell end caps. Like I said in my previous post the core dimensions are substantially the same as specified on the factory blue prints.
    
    MSL
    
    
    
    Builder of MagneQuest & Peerless transformers since 1989
    
    
    

    ---

    • RE: I made unofficial datasheets...with measurements - petercapo 14:28:46 04/17/15 (0)
      In Reply to: RE: I made unofficial datasheets...with measurements posted by mqracing on April 16, 2015 at 20:02:28

      Thank you, Mike. I will keep that possibility in mind.
      

      ---

Post a Followup:

This post is made possible by the generous support of people like you and our sponsors:

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---