|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
71.37.187.100
In Reply to: RE: Art Of The Karlson posted by freddyi on March 23, 2016 at 00:45:56
Hi freddyi
How do you go about designing enclosures for the Karlson?
I would like to build a pair of these for a desktop computer system.
I have several 4-6 inch full range drivers I could use.
The double stack is interesting but a single stack would be fine.
I would like to keep the base @ around 12 x 12 inches or smaller.
Are there any spreadsheets out there? or any sites that explain the
process? I searched briefly on google but nothing that helps.
Any information wold be appreciated.
Thanks Cal
Follow Ups:
Hi Cal
for a start read the XKi thread link below - - if you know or can measure your driver's parameters - then you could ask xrk971 at Diyaudio to run an Akabak simulation for you to size the cabinet, duct, and get the aperture
Karlson Evangelist
Your help is very much appreciated.
Cal
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: