|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
109.154.101.168
In Reply to: RE: speakers posted by bertdw on July 22, 2015 at 13:07:47
yes that gif is exactly how they are wired. Its just when I read the output from my multi meter I didn't get 8 ohms so after reading various pages and remaining confused I came here. I'm probably using the meter wrongly.
Follow Ups:
Is this a published design? It would be helpful to see a schematic. Are you sure your meter is accurate? If you have a low-value resistor (10 ohms or so) you could check the meter against it. Is the speaker completely wired? If you disconnect the woofer and measure the input terminals of the crossover, it should measure open, that is, infinite ohms. If not, the crossover is miswired, or it's a series crossover, which is a whole other beast.
Edits: 07/23/15
I just looked this up. You can measure only DC resistance with an typical Ohm meter that you are probably using. It should read about 6.4 ohms, or 80% of 8 ohms, for a 'nominal' 8 ohm loudspeaker. You, evidently, don't have a 'nominal' 8 ohm loudspeaker. Your reading seems too low, for even a 'nominal' 4 ohm loudspeaker. That's all I know about loudspeakers. Better post under the Speakers topic for a more informed viewpoint.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: