- Posted by Carl B. (A) on June 11, 2006 at 05:31:38
In Reply to: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? posted by Marshall W on June 10, 2006 at 21:23:44:
that's what I thought. they are unmarked and the top ends of the 10k resistors are not connected. I tried connecting my rca grounds there, no difference. I think russ is right(8 and 10 eyelets), but on the original dynaco diagram 8 and 10 is for the 10ohm resistors only. So I will have the 10ohm resistors and my rca grounds in there. 2 wires per eyelet? Does this make sense?
Follow Ups:
- Re: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? - Russ57 07:08:40 06/11/06
(0)
- In Reply to: Re: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? posted by Carl B. on June 11, 2006 at 05:31:38:
Terminals 8,9, and 10 are all a common ground so it really doesn't matter. Make sure to have a 10 ohm resistor, not 10K in series with the (between) the RCA outside shell and driver board ground on both sides with no other wiring attached to the RCA shell. There will be 2 extra 10 ohm resistor from the original mono/stereo switch that can be removed as well as any wiring.
Russ
This post is made possible by the generous support of people like you and our sponsors:
You can not post to an archived thread.
[
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]