Welcome! Need support, you got it. Or share you ideas and experiences.
218.188.205.199
In Reply to: RE: Time for a Major New Product Announcement - The EZ Ultimate Clock posted by bcherry on May 06, 2009 at 02:43:55
As many are asking: What if I've already installed one of the not-so-EZ clocks and removed parts from my motherboard?
Yes replacing removed surface mount parts especially can evoke some or all of pain, fear and loathing.
If you have already installed clocks the "hard way" we recommend using "XO" output and wiring the clock signal directly to the clock pin, basically the same way you have previously connected the clock.
But just soldering in the XTal adapter in the place of the original crystal with non of the removed parts replaced will be fine too.
DIY - Done Right!
Post a Followup:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2009, Audio Asylum, all rights reserved ]
[ Go Green ]
[ Take5 ]