|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
74.37.191.17
In Reply to: RE: Increase output voltage of DAC? posted by Ozzy on October 11, 2014 at 13:51:09
Something seems a little odd. I use a passive setup and have for many years. my DAC out is 2.35VRMS @50 ohms and my amps are 100K like yours and need a volt for full output and I bi-amp so my passive drives two amps.
So you have slightly higher output voltage but at a higher impedance (2.6@<800 ohms) and a little less sensitivity 1.25 vs 1 volt needed for full output.
Modding the DAC is probably one of the least easy solutions. Carcass said you have a Sonic Euphoria passive which I assume is TVC based. Try that and tell us what happens. Which taps do you use on the amps? Have you tried both?
In my system there is an occasional recording with a level so low I can't get full output from my amps but it still has enough volume to play quite loud by most peoples standards.
ET
Follow Ups:
SE is the thing of the past I guess, the same as for myself.
Yes but perhaps it is still around and he can try it. Something seems odd.
ET
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: