|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
76.104.217.128
In Reply to: RE: Supra LoRad 2.5 MK II posted by bjh on April 07, 2014 at 08:51:37
Another DIY design on the same VH Audio page has the shield connected at the AC plug end. There is no hard rule as to which end a drain wire or braided shield is connected, however most shielded designs (including shielded interconnect cables) feature the connection at the source end only, which in the case of a power cord is the AC plug. That said, some power cords do sound better when the shield is connected at the IEC connector end. You might consider experimenting with the drain wire connected at either end, or at both ends for that matter. That said, if you wish to be certain, you should ask the seller if the Supra LoRad Mk II drain wire is intended to be connected to the AC plug or the IEC connector.
Follow Ups:
Thanks
Never trust an Atom, they Make Up everything!
Where in USA/Canada is this cable available in bulk?
I purchased from eBay (member zendada, listing below). It shipped from the US but there were no additional fees/taxes ... I don't know if that was just luck or standard.
Never trust an Atom, they Make Up everything!
Edits: 04/09/14
Thanks. I noticed Madisound carries it as well - not sure if it's the Mk II version though.
i'm quite curious about this cable too.
what application are you using this cable in?
what plugs have you opted for? were plugs relatively easy to install?
how does this cord "sound" compared with other cords you've tried?
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: