- Posted by Steve Reese on December 31, 2001 at 11:15:05
I'm starting the construction of second Paramour amp, and while tightening the nut on the bolt that has the solder tab pointing towards terminal 6-10, the bolt came 'loose'. Meaning that the head of the bolt moves while trying to tighten with a screwdriver and a socket holding the nut. (tried vice- versa with same result.)Looking at that bolt, I notice there is a piece of either metal or lamination that has broken free. Will this hurt the performance of the powersupply? Please give any knowledge how I can handle this. All replies are welcome.
Happy New Year!!
Follow Ups:
- Re: Paramour powersupply -- Argent!!!! - Voltsecond 13:12:04 12/31/01
(1)
- In Reply to: Paramour powersupply -- Argent!!!! posted by Steve Reese on December 31, 2001 at 11:15:05:
It will probably buzz with you apply power. Buy a new brass bolt and you should be OK. Remember one grunt tight. ;-) (1/4 grunt if you have 20 inch biceps!)
- Thanks Voltsecond - Steve Reese 15:17:16 12/31/01
(0)
- In Reply to: Re: Paramour powersupply -- Argent!!!! posted by Voltsecond on December 31, 2001 at 13:12:04:
nt
- Thanks Voltsecond - Steve Reese 15:17:16 12/31/01
(0)
This post is made possible by the generous support of people like you and our sponsors:
You can not post to an archived thread.
[
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]