|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
75.100.188.177
In Reply to: RE: Of course... posted by Tre' on September 19, 2015 at 19:34:36
"Note: THD+N includes noise.
Noise (mainly thermal noise from resistors) dominates below 10W. Since the noise level is constant and absolute its amplitude relative to the test signal level, expressed in percents, is higher for lower signal levels. This in no way implies that distortion performance has an optimum at 10W but that at lower powers it is completely unmeasurable amongst the (very low) noise. This is why distortion spectra are only shown for high power levels where any distortion of note exists. "First Watt" performance is, in fact, first rate. "
try it! you know you want to!
Follow Ups:
I was reading the International Rectifier pdf.
The above is from the N-Core pdf that you linked and no, I don't see the note.
I searched the pdf for "Note: THD+N includes noise" and came up blank.
The above is not THD+N to start with.
BTW not that it matters but it looks like this one bottoms out at 6 watts vs. the 10 watts from the IR pdf.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
http://www.hypex.nl/docs/NC400_datasheet.pdf
try it! you know you want to!
I was looking at the nc1200 datasheet that you linked in this post,
http://www.audioasylum.com/forums/amp/messages/20/208394.html
The only thing that matters is how it sounds. Bring of over and we'll listen to it!
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
...is how it sounds.
Yep.
I guess you have now backed down from your objective claims.
try it! you know you want to!
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: