|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
69.142.61.77
In Reply to: RE: Source line attenuator question - Placette posted by AbeCollins on July 22, 2014 at 11:08:27
Again, I wanted to know about using this a source attenuator and not as a passive preamp.
charles
Follow Ups:
Am I not understanding what you're trying to do?
Are you trying to attenuate the output signal of a source component before it reaches a power amp?
Does the back of the volume controller have RCA jacks?
The mulitple input version seems to have a different jack on the rear of it?
charles
Again, are you trying to attenuate the output signal of a source component before it reaches a power amp?
Here's the back of the Placette Remote Volume Control:
Here's the back of the Placette Passive Linestage:
I would like to use it between source and power amp on one setup - classic passive setup.
And on my primary setup - between source and PREAMP input on my vintage gear. Basically a IR volume controller on this on.
It should work fine on both setups. You might need to adjust the PREAMP volume UP a bit, then use the Passive Volume Controller with remote to help attenuate the signal.
.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: