|
Amp/Preamp Asylum: You could make it work, but: by Ralph Looking for a new Amp or Preamp? If you're after tubes, post over here. |
For Sale Ads |
64.122.72.31
In Reply to: stereo, single ended phono pre used in single channel balanced mode? posted by Ugly on January 17, 2017 at 20:49:08:
First off, your CMRR (common mode rejection ratio) will be terrible! CMRR is actually pretty important in a case like this.
What is needed is at least a differential input! That would improve the CMRR quite a lot.
The problem is that the cartridge, which is indeed a balanced source, has its outputs on pins 2 and 3 of the XLR connection (if in fact that's what you plan to use). On any equipment that supports the balanced line standard, the inputs are pin 2 with respect to pin 3 and ground is ignored.
Your setup won't do that as it sits, but if the input circuit were somehow to get wired together differentially, you could make a go of it.
IMO its impractical. I think you're going run into hum problems and not much output, unless you can find an input transformer with a center tap on the secondary side feeding the preamps.
This post is made possible by the generous support of people like you and our sponsors:
Topic - stereo, single ended phono pre used in single channel balanced mode? - Ugly 20:49:08 01/17/17 ( 10)
- Update - Ugly 17:47:02 05/27/17 ( 0)
You could make it work, but: - Ralph 01/19/17 10:37:08 01/19/17 ( 2)
- You'd need a transformer (nt) - mr.bear 10:30:38 01/20/17 ( 0)
RE: You could make it work, but: - Ugly 14:06:56 01/19/17 ( 0)
RE: stereo, single ended phono pre used in single channel balanced mode? - b.l.zeebub 11:58:51 01/18/17 ( 1)
- RE: stereo, single ended phono pre used in single channel balanced mode? - Ugly 20:00:32 01/18/17 ( 0)
RE: stereo, single ended phono pre used in single channel balanced mode? - John Elison 02:23:39 01/18/17 ( 1)
- RE: stereo, single ended phono pre used in single channel balanced mode? - Ugly 08:13:40 01/18/17 ( 0)
I am pretty sure it cannot work... - 3+4=5 21:57:37 01/17/17 ( 1)
- RE: I am pretty sure it cannot work... - Ugly 22:55:40 01/17/17 ( 0)