Home
AudioAsylum Trader
Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

RE: Operating SE trans just at limit current...

Posted by mqracing on June 6, 2007 at 10:35:18:

Hi Somejoe:

If available you really need the advice and knowledge of the builder of your iron. Here is why;

there is a lot of confusing ways to state dc current values and limits on a SE output transformer.

Some companies print a large number and call it--- Maximum DC current or such. But this number uses ALL of the available flux density of the transformer--- leaving no magnetic headroom for the AC signal. It is or can be essentially a measure of how much DC current by itself the trans can absorb before reaching it's saturation point.

You'll note that some companies publish a BIG dc current number--- but do all of their own testing at a much smaller DC current level. this is in practice the real dc current level that the trans will comfortably support if you value fidelity.

Not picking on anyone or any company--- but as an example--- look at some Tango specs for SE outputs. They will print a larg MAX value of DC current--- but when you look at where they test the unit it is most times at about half of this value.

Any transformer only has a certain amount (call it X) of flux density available. If you consume all of this flux with the dc current then you will have little or no capacity for the transformer to handle the AC (your music).

Another good clue to use--- is see if the manufacturer shows under what conditions they get their advertised L figure. Use that as a moreso reliable guide as opposed to just using the max number that may be printed.

MSL