Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Vinyl Asylum ]

---

[ Alert Moderator ]

---

RE: Denon DL-103 / Jensen JT-44K-DX stepup - loading resistor value?

Posted by John Elison (A) on October 15, 2007 at 18:44:03

In Reply to: Denon DL-103 / Jensen JT-44K-DX stepup - loading resistor value? posted by VirginVinyl on October 15, 2007 at 17:00:22:

According to Jensen, the JT-44K-DX is designed to be connected directly to a 47k-ohm phono preamp with only a series RC termination across the secondary as shown in the following schematic. Jensen says that for a 40-ohm cartridge the termination should be 6.04k-ohms in series with 130-pF. Have you tried this kind of termination? It seems like it would be weighted toward the high frequencies because of the series capacitor.

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---