Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
Question is pretty much self explanatory. I have an AR ES-1 that I've been using on and off for many years, and would like to give it some TLC. I already have a new belt and lubed the motor (lightly). I'm not quite sure how to clean out (and even check) the bearing well once the inner platter is removed.
This post is made possible by the generous support of people like you and our sponsors:
Topic - How does one clean out bearing well? - tonyptony 12:30:39 09/17/06 (16)
- Re: How does one clean out bearing well? - jtsjf 18:36:17 09/17/06 (1)
- Carb cleaner good suggestion... - grailer 06:36:11 09/18/06 (0)
- Good suggestions. Is this also doable? - tonyptony 14:11:55 09/17/06 (11)
- Re: Good suggestions. Is this also doable? - mosin 14:18:14 09/17/06 (10)
- I recently tried electric motor cleaner and it worked - richardl 11:00:20 09/18/06 (0)
- Ronsonal - InDaGroove 18:47:02 09/17/06 (6)
- Re: Ronsonal - tonyptony 19:49:18 09/17/06 (4)
- Re: Ronsonal - InDaGroove 20:31:36 09/17/06 (3)
- Naptha - J.D. 22:43:03 09/17/06 (2)
- Re: Naptha - tonyptony 05:08:58 09/20/06 (0)
- Naptha? - mosin 11:06:17 09/18/06 (0)
- Re: Ronsonal - mosin 19:22:37 09/17/06 (0)
- Re: Good suggestions. Is this also doable? - tonyptony 16:14:08 09/17/06 (1)
- Re: Good suggestions. Is this also doable? - mosin 16:21:06 09/17/06 (0)
- Lighter fluid works too (nt) - Fretless 13:23:06 09/17/06 (1)
- Re: How does one clean out bearing well? - grailer 12:46:10 09/17/06 (0)