Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Spindle bearing cleaned and oiled, adjustments made per Service Manual. posted by M3 lover on September 15, 2006 at 10:08:05:
Since the strobe runs on the same crystal as the motor drive it will not show changes due to crystal circuit errors.Check the waveform at pin 5 of IC3 on the logic board for correct period (1.14 us). If it's off, adjust trimmer C210. If it's right, check pin 1 of IC5 and so on.
Mark Kelly
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- To be expected - Mark Kelly 16:32:07 09/15/06 (2)
- Mark - more info - M3 lover 17:16:59 09/15/06 (1)
- No manual - Mark Kelly 17:46:17 09/15/06 (0)