|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: I thought .4-.6 wasn't low output posted by Mr. Black on September 12, 2006 at 11:57:15:
The next question arises about the loading. Does your preamp have switchable loading? IOW's is there a switch near the phono input marked MC-MM. If so, you can probably use the cartridges if you switch it to the MC setting.(MC = moving coil which usually has a loading of 100 ohms vs moving magnet which loads at 47k ohms.) However you may need to turn up the volume quite a lot more than normal, because you are right on the cusp of needing more gain. If you have the MC switch, one of the cartridges you mentioned might be worth a try. if you find you don't have enough gain, then you can get the tranny. K&K makes a pretty good one for the $$$. They are a sponsor here also. The cost is about $200 assembled. Hope this helps
I only use my gun whenever kindness fails
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- .4 & .6 is still considered low output. High output is usually 2.0 and above - artemus 13:31:35 09/12/06 (1)
- Thanks - Mr. Black 12:11:41 09/13/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
