|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Clumping... posted by tketcham on September 9, 2006 at 08:03:26:
but it also sounds like more tediousness on top of a labor intensive process already. But I will try it if the stiffer bristle brushes dont work out for me. ~ All suggestions get filed.Also, don't you have a lot more liquid to vacuum up? You must have a pretty drippy record. I get a lot of the fluid off in my vacuuming. The record has to air dry for several minutes. I will have to try it and see.
I do 10 records at a time. it takes me up to two hours to complete the process because I give 'em time after the sink bath that I don;t have to wipe them dry on one side so I don't foul the pad I use on the manual RCM. I'm getting streamlined but oofah. I am too exact, that's the problem. I can clean the ehll out of a record. Now soldering a PCB, I am a piker in that regard.
~Slainte,
The OMalley
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- sounds like that might work - OMalley 08:18:09 09/09/06 (8)
- RCM's suck... - tketcham 08:35:34 09/09/06 (7)
- Re: RCM's suck... - blake 17:34:53 09/09/06 (1)
- Good points. That Electrolux of mine is going on 23 years old and still runs like a champ. nm - tketcham 22:27:29 09/09/06 (0)
- i am so cheap - OMalley 09:28:59 09/09/06 (4)
- So was I until I wasted $75 on Orbitrac stuff. Went from cheap to chump... - tketcham 10:55:27 09/09/06 (3)
- it is a rip off - OMalley 11:14:08 09/09/06 (2)
- Now I feel better. A $75 plastic brush case. '-) nm - tketcham 11:33:18 09/09/06 (1)
- very trendy - OMalley 15:29:08 09/09/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]