Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Acrylates? posted by Mark Kelly on December 17, 2005 at 22:10:55:
That's my primary concern. I used some on the outside of the joint however, and that may help to keep it together. My first inclination was to use gel type super glue, but I was concerned about the working time. If it stuck before the tip was properly aligned, the cartridge was a piece for the junkpile. Then, there was the alternative of a two-part epoxy. I have a particularly thin one that is specified for marine and aircraft applications that has a forty-five minute setting time, but it doesn't cure as hard as I would like. My gut feeling is that a two-part is probably the one to use, but what is the formulation? That's most likely a secret we will never find out about. In any event, my results on this one look promising, so far.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Right. - mosin 22:23:45 12/17/05 (1)
- I forgot...of course. - mosin 22:38:01 12/17/05 (0)