Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: How do I safely drill plexi-glass? posted by carlschenke@bellsouth.net on August 4, 2005 at 09:51:02:
The special plexi bits work extremely well. I keep several different ones on hand. I do prefer to use a press, though and a masking tape over the surfaces. Be careful as the bits heat up quite a bit, and a cooler bit cuts better, as the heat causes the plexi to bond to the bit. You can spray water on as you drill for cooling. Of course with just a few holes, you may think this unnecessary, but it helps.
Stu
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: How do I safely drill plexi-glass? - unclestu52 11:35:09 08/04/05 (1)
- Re: How do I safely drill plexi-glass? - Dan_ed 17:26:51 08/04/05 (0)