Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Technics SL-1200 Alignment posted by frankwm on February 20, 2017 at 00:23:11:
Hi Frank,
I don't mind the intrusion at all. I would just like to get the bottom of this.
Normally SME provides more parameters than effective length. Nowadays, SME provides pivot-to-spindle and offset angle in addition to effective length. These three parameters define the tonearm geometry completely. In fact, any three independent parameters defines a unique tonearm geometry for which all other parameters can be determined. I truly believe that "Distance from Bedplate Center to Turntable Center" is pivot-to-spindle distance for the specified effective length. Therefore, here are the numbers directly from the manual of the Early SME Series III:
Effective Length = 229-mm
Pivot-to-Spindle = 215.4-mm
.
I owned the "later" version of the SME III, which was designed for Lofgren A geometry within the IEC modulated groove envelope. It had alignment null-points of 66.00-mm and 120.89-mm.
.
I'll take your word for the older Series II tonearm having an outer null-point of 117.42-mm since you measured it. However, if I find any SME published information I'll keep you posted.
Thanks,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Technics SL-1200 Alignment - John Elison 05:28:47 02/20/17 (17)
- RE: Technics SL-1200 Alignment - frankwm 05:41:45 02/20/17 (16)
- RE: Technics SL-1200 Alignment - John Elison 12:38:08 02/20/17 (15)
- RE: Technics SL-1200 Alignment - flood2 20:01:27 02/21/17 (14)
- RE: Technics SL-1200 Alignment - John Elison 07:31:02 02/22/17 (10)
- Stevenson's Socket... - frankwm 09:16:34 02/22/17 (9)
- Your right! - John Elison 00:29:47 02/24/17 (8)
- RE: Your right! - frankwm 02:27:29 02/24/17 (1)
- RE: Your right! - John Elison 12:41:44 02/24/17 (0)
- RE: Your right! - flood2 02:11:14 02/24/17 (5)
- RE: Your right! - John Elison 05:12:00 02/24/17 (4)
- RE: Your right! - flood2 01:41:02 02/25/17 (3)
- RE: Your right! - John Elison 05:45:32 02/25/17 (2)
- RE: Your right! - flood2 23:43:20 02/26/17 (1)
- RE: Your right! - John Elison 03:30:25 02/27/17 (0)
- RE: Technics SL-1200 Alignment - John Elison 05:55:20 02/22/17 (2)
- RE: Technics SL-1200 Alignment - flood2 15:08:48 02/22/17 (1)
- RE: Technics SL-1200 Alignment - John Elison 23:29:50 02/22/17 (0)