Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Technics SL-1200 Alignment posted by frankwm on February 19, 2017 at 11:53:55:
I know that 60.325-mm is the inner null-point for Stevenson's alignment, but what about the outer null-point? I can't find the offset for any of the SME tonearms. However, if I could find the pivot-to-spindle distance of the SME Series II, that would tell me if it's possible for it to have Stevenson's alignment with the outer null-point. The parameter that SME states in the manual is "Distance from Bedplate Center to Turntable Center." If this is pivot-to-spindle mounting distance, then it's not possible for SME II and III tonearms to be Stevenson. Sure, you can align the inner null-point to 60.325-mm, but the outer null-point will not be a Stevenson null-point.
What makes you think the SME II and III use Stevenson geometry. If you're going by the null-points published in the Vinyl Engine, those are erroneous. I don't know how the Vinyl Engine came up with those null-points, but they are wrong. Either the null-points are wrong or else the other listed parameters are wrong.
Best regards,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Technics SL-1200 Alignment - John Elison 22:20:40 02/19/17 (19)
- RE: Technics SL-1200 Alignment - frankwm 00:23:11 02/20/17 (18)
- RE: Technics SL-1200 Alignment - John Elison 05:28:47 02/20/17 (17)
- RE: Technics SL-1200 Alignment - frankwm 05:41:45 02/20/17 (16)
- RE: Technics SL-1200 Alignment - John Elison 12:38:08 02/20/17 (15)
- RE: Technics SL-1200 Alignment - flood2 20:01:27 02/21/17 (14)
- RE: Technics SL-1200 Alignment - John Elison 07:31:02 02/22/17 (10)
- Stevenson's Socket... - frankwm 09:16:34 02/22/17 (9)
- Your right! - John Elison 00:29:47 02/24/17 (8)
- RE: Your right! - frankwm 02:27:29 02/24/17 (1)
- RE: Your right! - John Elison 12:41:44 02/24/17 (0)
- RE: Your right! - flood2 02:11:14 02/24/17 (5)
- RE: Your right! - John Elison 05:12:00 02/24/17 (4)
- RE: Your right! - flood2 01:41:02 02/25/17 (3)
- RE: Your right! - John Elison 05:45:32 02/25/17 (2)
- RE: Your right! - flood2 23:43:20 02/26/17 (1)
- RE: Your right! - John Elison 03:30:25 02/27/17 (0)
- RE: Technics SL-1200 Alignment - John Elison 05:55:20 02/22/17 (2)
- RE: Technics SL-1200 Alignment - flood2 15:08:48 02/22/17 (1)
- RE: Technics SL-1200 Alignment - John Elison 23:29:50 02/22/17 (0)