Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: EAR 834p V3 posted by SpotcheckBilly12345 on February 9, 2017 at 08:50:30:
Continued the comparison between the EI 12ax7 and the Mullard 12au7. As before, very small differences if any, and perhaps in the end favoring the EI. Since the designer recommends a 12ax7 in all three tube positions, I would conclude leaving an ax7 in V3. Tried a few other ax7s in V3 including a JJ and Shuguang, and the EI is clearly the best amongst these.
From earlier tube rolling sessions, like some others I found a 5751 in V1 a significant improvement over a 12ax7. Consensus is that V2 is a primary contributor to the RIAA equalization circuit and should always be a 12ax7.
Hope that helps. There are dozens of opinions out there on tube makes and types in the 834P. Good luck sorting them out!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: EAR 834p V3 - BRab 14:29:33 02/09/17 (1)
- RE: EAR 834p V3 - SpotcheckBilly12345 07:40:25 02/10/17 (0)