RE: Thanks again Anthony. To make sure I understand your answer,

Posted by flood2 (A) on January 11, 2017 at 18:07:21

In Reply to: Thanks again Anthony. To make sure I understand your answer, posted by alaskahiatt on January 11, 2017 at 15:46:04:

Hi

Yes, that is correct. I would expect a lump at around 11kHz or so and rapid loss of HF. Similar effect to what you get if you try and put a VN5XMR in an Shure M97xE body.

Expert used to deal with Stanton and supplied them with the original 78rpm alternative styli until Stanton started trying to do go it alone (apparently)! They are very familiar with the designs and will test out the suspension and technical performance before proceeding. They don't undertake anything they deem to be unnecessary or uneconomical so your cartridge is in safe hands.
Regards Anthony

"Beauty is Truth, Truth Beauty.." Keats

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - A few vintage, high-compliance cartridges - mr.bear 00:02:46 01/08/17 (12)

RE: A few vintage, high-compliance cartridges - Wojciech 19:00:24 01/11/17 (1)

RE: A few vintage, high-compliance cartridges - flood2 12:44:02 01/13/17 (0)

RE: A few vintage, high-compliance cartridges - rindolini 14:40:11 01/08/17 (2)

RE: A few vintage, high-compliance cartridges - flood2 02:50:28 01/09/17 (0)

RE: A few vintage, high-compliance cartridges - mr.bear 01:36:42 01/09/17 (0)

Do you have a Pickering XV-15 that could use the 4500Q stylus? - alaskahiatt 11:20:57 01/08/17 (6)

RE: Do you have a Pickering XV-15 that could use the 4500Q stylus? - flood2 02:38:37 01/09/17 (5)

Anthony, if my reading is correct, my XV-15 can accept the MI D2000Q stylus. - alaskahiatt 17:08:51 01/09/17 (3)

RE: Anthony, if my reading is correct, my XV-15 can accept the MI D2000Q stylus. - flood2 18:00:59 01/09/17 (2)

Thanks again Anthony. To make sure I understand your answer, - alaskahiatt 15:46:04 01/11/17 (1)

RE: Thanks again Anthony. To make sure I understand your answer, - flood2 18:07:21 01/11/17 (0)

Thank you very much. I can see that I need to do a little more reading. nt - alaskahiatt 07:39:46 01/09/17 (0)

Follow Ups

RE: Thanks again Anthony. To make sure I understand your answer, - flood2 18:07:21 01/11/17 (0)

RE: Thanks again Anthony. To make sure I understand your answer,

Post a Message!