RE: Can't tell from the picture

Posted by Mel (A) on January 10, 2017 at 07:48:32

In Reply to: Can't tell from the picture posted by texanater on January 10, 2017 at 05:17:51:

I have nothing to add to this discussion specifically on the Technics bearing. However, about the oil: Jim upgraded my VPI non-inverted bearing and sent along some very special oil with it, and a clearly heavier grade than standard factory. I recall that it took a VERY long time for the bearing to settle in, so much so that I thought something was wrong. But he reassured me it would be fine and it was VERY fine.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Applied Fidelity Bearing Identification and advice. - wayne lab 04:16:10 01/10/17 (16)

RE: Applied Fidelity Bearing Identification and advice. - jkaschyk 10:44:51 01/10/17 (10)

P.S. - jkaschyk 10:52:46 01/10/17 (9)

RE: P.S. - wayne lab 04:15:13 01/11/17 (6)

RE: P.S. - wayne lab 04:16:43 01/11/17 (5)

RE: P.S. - jkaschyk 06:28:50 01/11/17 (4)

RE: P.S. - wayne lab 01:16:47 01/14/17 (1)

RE: P.S. - jkaschyk 07:25:03 01/14/17 (0)

RE: P.S. - wayne lab 10:59:56 01/11/17 (1)

RE: P.S. - jkaschyk 11:43:13 01/11/17 (0)

RE: P.S. - wayne lab 01:48:45 01/11/17 (1)

I do not think spinning it will cause any problems - Penguin 21:01:16 01/12/17 (0)

RE: Applied Fidelity Bearing Identification and advice. - louie3 06:28:27 01/10/17 (0)

Can't tell from the picture - texanater 05:17:51 01/10/17 (3)

RE: Can't tell from the picture - Mel 07:48:32 01/10/17 (0)

RE: Can't tell from the picture - wayne lab 05:29:46 01/10/17 (1)

RE: Can't tell from the picture - texanater 05:44:13 01/10/17 (0)

Follow Ups

RE: Can't tell from the picture - Mel 07:48:32 01/10/17 (0)

RE: Can't tell from the picture

Post a Message!