Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Why turntable bearing shaft and spindle machined as one piece? posted by John Elison on October 24, 2016 at 04:59:18:
John, Yes, the bearing shaft/spindle is bolted directly to the plinth, and the ball bearing is press-fitted into the end of the shaft, where the platter then goes over it. The shaft and bearing are stationary. Harry made a special oil-pumping feature for me in the platter for the inverted bearing. The entire operation is very quiet with black background. The platter is controlled by rim-drive off the HRX double motor and sounds great with the 3D arm and Lyra Titan-i cartridge. I also use the Phoenix Engineering Eagle and RoadRunner.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Why turntable bearing shaft and spindle machined as one piece? - Hiendmuse 07:36:02 10/24/16 (1)
- Okay! Thanks! /nt\ - John Elison 08:42:27 10/24/16 (0)