Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Why turntable bearing shaft and spindle machined as one piece? posted by caffeinator on October 23, 2016 at 10:37:07:
IF so concerned?
Ream out your LP centers and fit a bit of silicone ring/tube as an Isolator so the lp never directly contacts the spindle..
IF the LP has no direct contact to the spindle the Problem(?) is moot.
Edits: 10/23/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Because God gave us TT mats :-) - bare 10:48:02 10/23/16 (4)
- Why not just machine down the spindle - Penguin 14:46:13 10/23/16 (1)
- As markinuk mentioned above, Roksan does just that - 1973shovel 18:28:39 10/23/16 (0)
- 'At's an awful lot o' reamin'... - genungo 11:29:44 10/23/16 (0)
- RE: Because God gave us TT mats :-) - caligari 11:28:01 10/23/16 (0)