Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
a few general questions....I think the ball used on these bearings is smaller than the shaft, but i have no positive knowledge of that.
So if you know...which configuration is used?
the one on the left or the one on the right....or asking it differently, is the ball fastened to the end of shaft or the thrust pad is fastened to the shaft?
The reason behind these questions is because i need to assemble a motor that Jim Howard could not finish for me. And as luck have it there are not to many people that can answer questions....
dee
;-D
True terror is to wake up one morning and discover that your high school class is running the country.
quote by Kurt Vonnegut
Edits: 09/21/16
This post is made possible by the generous support of people like you and our sponsors:
Topic - All you guys out there with Applied Fidelity bearings - Penguin 21:39:59 09/21/16 (13)
- All you guys out there - hifitommy 21:59:58 09/22/16 (5)
- Zebra joke? - Penguin 17:03:06 09/23/16 (2)
- RE: Zebra - hifitommy 17:33:28 09/23/16 (1)
- It would not be PC for either of us tell the joke :)... - Penguin 17:59:49 09/23/16 (0)
- RE: All you guys out there... - John Elison 23:22:52 09/22/16 (1)
- SALUTE! - hifitommy 13:26:12 09/23/16 (0)
- Tubes liked to take pictures... - John Elison 06:12:03 09/22/16 (3)
- Thanks John - Penguin 10:05:03 09/22/16 (2)
- You're welcome! /nt\ - John Elison 18:22:11 09/22/16 (0)
- Yes, thanks very much John. - alaskahiatt 12:01:21 09/22/16 (0)
- I know for sure - EdAInWestOC 06:00:51 09/22/16 (0)
- Logic says the ball below would ride higher, the ball on top lower. Which way sits at correct height? nt - Smelly_Socks 21:54:56 09/21/16 (1)
- unfortunately logic is no use here - Penguin 22:26:36 09/21/16 (0)