RE: To B&O or NOT

Posted by Awe-d-o-file (D) on July 23, 2016 at 15:59:48

In Reply to: RE: To B&O or NOT posted by cpielock@eaglebrook.org on July 22, 2016 at 18:24:41:

We were the B&O repair facility and they had a pretty low failure rate. They werent hard to work on once you did a few and got used to their design. Good feedback isolation. Something to be said for the low mass arm.

ET

"If at first you don't succeed, keep on sucking till you do suck seed" - Curly Howard 1936

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - To B&O or NOT - ivan382 20:26:03 07/21/16 (16)

RE: To B&O or NOT - coffee-phil 11:29:22 07/22/16 (4)

RE: To B&O or NOT - cpielock@eaglebrook.org 18:24:41 07/22/16 (1)

RE: To B&O or NOT - Awe-d-o-file 15:59:48 07/23/16 (0)

RE: To B&O or NOT - ivan382 14:40:37 07/22/16 (1)

RE: To B&O or NOT - Awe-d-o-file 08:51:15 07/23/16 (0)

RE: To B&O or NOT - jec01 10:18:06 07/22/16 (0)

RE: RX-2 - thegage 05:01:19 07/22/16 (1)

RE: RX-2 - fstein 09:38:00 07/22/16 (0)

Having owned a Rega in the past... - olddude55 02:51:02 07/22/16 (4)

2nd. I have a Planar 2 and RX-2. - ToddM 12:03:26 07/22/16 (3)

I used to have a Planar 2, and used to have an RX2 too... - bcowen 18:41:43 07/22/16 (1)

Too bad B&O never made an RX-4. Nt - olddude55 19:12:43 07/22/16 (0)

RE: 2nd. I have a Planar 2 and RX-2. - olddude55 13:56:06 07/22/16 (0)

Look for a B&O TX2 liner table... - Cougar 20:42:40 07/21/16 (2)

Have a TX2 with the Soundsmith SMMC3 and... - popsy 07:02:13 07/22/16 (1)

RE: Have a TX2 with the Soundsmith SMMC3 and... - Cougar 12:02:15 07/25/16 (0)

Follow Ups

RE: To B&O or NOT - Awe-d-o-file 15:59:48 07/23/16 (0)

RE: To B&O or NOT

Post a Message!