Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? posted by Erocka2000 on May 24, 2016 at 08:30:48:
The magnet for the roadrunner normally attaches to the underside of the platter, which doesn't look like an option for the 124. It might be possible to put the magnet on the bottom edge of the side of the platter and then set the sensor sideways to read the magnet.
I would definitely contact Phoenix Engineering about this.
Would you need the Eagle (vs the Falcon) because the Thorens requires a lot of torque?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? - steve.ott@kctcs.edu 10:52:26 05/24/16 (6)
- RE: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? - Erocka2000 11:46:58 05/24/16 (5)
- RE: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? - bill_stevenson@bellsouth.net 10:28:41 05/26/16 (1)
- RE: Link - Travis 11:33:40 05/26/16 (0)
- RE: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? - louie3 06:54:29 05/25/16 (1)
- RE: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? - Hiendmuse 07:57:22 05/25/16 (0)
- RE: Phoenix Roadrunner/Eagle PSU with a Thorens TD-124? - steve.ott@kctcs.edu 14:22:39 05/24/16 (0)