do not touch the screws..

Posted by Penguin (A) on May 22, 2016 at 17:15:09

In Reply to: RE: Rather than guessing posted by TMol on May 22, 2016 at 16:56:38:

Unless you are ready to redo the bearing s :)...

It can be done, but it is a challenge for all but the most experienced tonearm jockeys. Those screws are used to preload the pivot bearings. The adjustment is a very touchy feely procedures. over tightening them will make you arm stick under tightening them will case bearing chatter and cause distortion.

dee
;-D

True terror is to wake up one morning and discover that your high school class is running the country.

quote by Kurt Vonnegut

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Should I be concerned here? - TMol 13:33:20 05/22/16 (13)

check the arm - Penguin 15:56:14 05/22/16 (2)

RE: check the arm - TMol 17:07:49 05/22/16 (1)

you are good on stiction.... - Penguin 17:13:11 05/22/16 (0)

Rather than guessing - 1973shovel 15:33:35 05/22/16 (2)

RE: Rather than guessing - TMol 16:56:38 05/22/16 (1)

do not touch the screws.. - Penguin 17:15:09 05/22/16 (0)

RE: Should I be concerned here? - John Elison 14:21:52 05/22/16 (4)

RE: Should I be concerned here? - slapshot 15:12:18 05/22/16 (0)

RE: Should I be concerned here? - TMol 15:08:46 05/22/16 (2)

RE: Should I be concerned here? - PAR 15:36:31 05/22/16 (1)

RE: Should I be concerned here? - TMol 16:58:48 05/22/16 (0)

RE: Should I be concerned here? - AudioSoul 14:03:57 05/22/16 (1)

RE: Should I be concerned here? - TMol 15:12:21 05/22/16 (0)

Follow Ups

do not touch the screws.. - Penguin 17:15:09 05/22/16 (0)

do not touch the screws..

Post a Message!