Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
Hey everyoneI'm hoping somebody can help me out here. I have an Audio research PH3 phono preamp that I'm trying to match with my Dynavector 20xM (VPI 1 mv version) cartridge. Specifically I need some help on loading.
According to the supplied specs the Recommended Load is: "Great Than 1,000ohms"
Any tips on recommended values to try? I'm such a novice that having any tips as far as where to purchase these resistors would also help (apparently Radio Shack is a no no).
The ARC service guy is unavailable right now.
I actually did this before (when i lived in Boston my repair guy loaded it down to 1000ohms but the sound ended up being a bit too dull). I removed the resistors and went back to 47k not knowing I could pick a value between the two.
Thanks in advance!
Edits: 02/10/16
This post is made possible by the generous support of people like you and our sponsors:
Topic - ARC PH3 Loading for Dynavector 20xM - Pyfite 08:15:12 02/10/16 (4)
- RE: ARC PH3 Loading for Dynavector 20xM - Pyfite 12:13:13 02/10/16 (0)
- RE: ARC PH3 Loading for Dynavector 20xM - pictureguy 09:25:06 02/10/16 (0)
- Try 5000-ohms.... - John Elison 08:43:43 02/10/16 (1)
- RE: Try 5000-ohms.... - Pyfite 09:19:48 02/10/16 (0)