RE: Uncurable warp

Posted by flood2 (A) on February 9, 2016 at 16:14:12

In Reply to: Uncurable warp posted by akolegov on February 6, 2016 at 00:15:10:

Hi

How thick is the pressing you are trying to flatten? I was dealing with a record that was about 1.14mm thick. I noticed that tightening the wing nut by the recommended amount (well you can't really tighten much further anyway!) doesn't close up the gap enough to flatten the warp properly. It requires additional clamping on the two wings of the outer metal VinylFlat slabs themselves to "fix" the warp.

Trying to fix clamps inside the pouch is challenging given the clearance since you can't use ordinary clamps - I suggest using string to tie the wings of each half of the VinylFLat.

Regards Anthony

"Beauty is Truth, Truth Beauty.." Keats

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Uncurable warp - akolegov 00:15:10 02/06/16 (9)

RE: Uncurable warp - flood2 16:14:12 02/09/16 (2)

RE: Uncurable warp - akolegov 21:39:18 02/09/16 (1)

RE: Uncurable warp - flood2 22:22:34 02/09/16 (0)

RE: Uncurable warp - Monchi 05:56:53 02/06/16 (5)

RE: Uncurable warp - akolegov 08:47:41 02/06/16 (4)

RE: Uncurable warp - Monchi 09:33:07 02/06/16 (3)

RE: Uncurable warp - akolegov 14:38:00 02/06/16 (1)

RE: Uncurable warp - Monchi 04:29:15 02/08/16 (0)

RE: Uncurable warp - akolegov 13:30:37 02/06/16 (0)

Follow Ups

RE: Uncurable warp - flood2 16:14:12 02/09/16 (2)

RE: Uncurable warp - akolegov 21:39:18 02/09/16 (1)

RE: Uncurable warp - flood2 22:22:34 02/09/16 (0)

RE: Uncurable warp

Post a Message!