Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Suspension changes would be extra work, no? posted by Lew on July 30, 2015 at 07:30:58:
Normally, even if a cantilever is changed, it would be replaced at the joint pipe leaving the damper and suspension alone. Otherwise the internals would have to be rebuilt. I guess it would depend on the cart, but IMO the 103D might not warrant more than a cantilever/tip replacement.
I bought an old Denon table w/Unitrac arm and DL103D. That was a popular match back in the day. The arm is 7g. I think 27cu might be an overestimate? Max VTF is 1.7g and compliance is 12cu @ 100Hz. The Ittock is 10g?? It should be fine. In my experience most high compliance Denon MC's, 304, DL-S1, sound best on arms of similar mass, even a little higher.
neo
BIRD LIVES
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Suspension changes would be extra work, no? - neobop 14:28:04 07/30/15 (1)
- It is ~ 27Hz @ 10 Hz where most Cart mfrs usually quote their figure. - Timbo in Oz 20:20:56 07/30/15 (0)