RE: link ...

RE: link ...

Posted by TBone (A) on March 27, 2015 at 11:56:47

In Reply to: RE: link ... posted by jorisdallaire on March 27, 2015 at 11:46:51:

Linn black oil, I think, used Moly.

I'm not a fan of these type of additives within a turntable bearing, unless the manufacturer recommends.

I would only use an oil that had a specified weight, and a list of additives. Otherwise, well, detergents are bad enough, but sulfur and bronze don't tend to react well over time.

So once again, be careful.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - acer racing sin bearing oil - jorisdallaire 08:28:12 03/27/15 (13)

I might not have been clear... - jorisdallaire 10:58:53 03/27/15 (5)

so let's clarify ... - TBone 11:01:06 03/27/15 (4)

RE: so let's clarify ... - jorisdallaire 11:04:32 03/27/15 (3)

link ... - TBone 11:12:03 03/27/15 (2)

RE: link ... - jorisdallaire 11:46:51 03/27/15 (1)

RE: link ... - TBone 11:56:47 03/27/15 (0)

Not to mention... - MannyE 08:46:43 03/27/15 (6)

RE: Not to mention... - Crazy Dave 12:17:49 03/27/15 (0)

again, be VERY careful ... - TBone 09:37:28 03/27/15 (4)

Agreed...it would be... - MannyE 10:03:46 03/27/15 (3)

I've witnessed too many ... - TBone 10:21:35 03/27/15 (2)

DIY is like the stock market. - MannyE 08:17:23 03/28/15 (1)

or gambling with Moly ... - TBone 07:06:41 03/29/15 (0)

Follow Ups

RE: link ... - TBone 11:56:47 03/27/15 (0)

Post a Message!