Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
I have a Grado Statement 1 cart and have been using a Heed Quasar phono pre. On a lark, I just acquired a tube phono pre, but will need to step up the Statement1's output. It puts out .5 mV, and prefers a 47k ohm load. What would work for this? Are any SUT's flexible enough on the input load to match this MI? Thank you.
This post is made possible by the generous support of people like you and our sponsors:
Topic - what SUT for a low-output Moving Iron cart (.5mV output, 47kohms input load)? - Chuck 06:01:32 03/01/15 (5)
- Are you sure it prefers 47k? - Penguin 20:18:09 03/01/15 (1)
- thank you (nt) - Chuck 04:48:01 03/02/15 (0)
- thank you both very much! (nt) - Chuck 19:11:15 03/01/15 (0)
- RE: what SUT for a low-output Moving Iron cart (.5mV output, 47kohms input load)? - John Elison 15:05:59 03/01/15 (0)
- RE: what SUT for a low-output Moving Iron cart (.5mV output, 47kohms input load)? - Tre' 07:00:59 03/01/15 (0)