Papst motor with SDS

Posted by phoenixengr (A) on February 26, 2015 at 14:46:54

In Reply to: Better! posted by CometCKO on February 25, 2015 at 16:36:58:

Just curious...what kind of output voltage are you getting with the SDS hooked up to that motor?

I know they rate the SDS at 20W, but you might want to look at what temp the heat sink on the output devices is reaching (you will have to remove the top cover to measure this). When I put an SDS on a Lenco (15W) motor, the heatsink exceeded 70°C which means the transistor junction temps were probably near their limit. I'd hate to see you blow up an expensive supply.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - The EMPIRE strikes back - CometCKO 14:39:38 02/25/15 (9)

is it still an EMPIRE? ... And what did all that cost? Nt - bjh 15:23:31 02/25/15 (1)

Probably not - CometCKO 16:15:29 02/25/15 (0)

Another pic - CometCKO 15:03:29 02/25/15 (0)

RE: The EMPIRE strikes back - CometCKO 14:57:07 02/25/15 (5)

RE: The EMPIRE strikes back - 6bq5 15:33:27 02/25/15 (4)

Better! - CometCKO 16:36:58 02/25/15 (3)

Papst motor with SDS - phoenixengr 14:46:54 02/26/15 (2)

Yeah, I saw your posts on this & the video on YouTube - CometCKO 20:26:43 02/26/15 (1)

RE: Yeah, I saw your posts on this & the video on YouTube - phoenixengr 10:53:43 02/27/15 (0)

Follow Ups

Papst motor with SDS - phoenixengr 14:46:54 02/26/15 (2)

Yeah, I saw your posts on this & the video on YouTube - CometCKO 20:26:43 02/26/15 (1)

RE: Yeah, I saw your posts on this & the video on YouTube - phoenixengr 10:53:43 02/27/15 (0)

Papst motor with SDS

Post a Message!