Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: cutting posted by ringwear on October 22, 2014 at 19:19:48:
I drill/mill out the front of the body and the bit will stop when it hits the pole piece. I then carefully clean out the hole to expose more of the pole piece, a flat piece of steel (nickel) so i can place the magnet directly against the pole piece.
A bitch and my ancient fingers cramp holding the cartridge body, Be careful if you attempt as squeezing it too hard can break the coil wires.
Incidentally, I must congratulate you. I've posted about modding cartridges in the past, but you actually started to do mods on your own. It's cool that you've broken the typical consumer mold....
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- more radical - unclestu 17:02:57 10/23/14 (9)
- mutual appreciation society - ringwear 18:00:53 10/23/14 (8)
- RE: mutual appreciation society - unclestu 21:47:06 10/23/14 (7)
- ferro fluid - ringwear 05:40:34 10/24/14 (6)
- RE: ferro fluid - unclestu 14:52:55 10/24/14 (5)
- out - ringwear 15:05:48 10/24/14 (4)
- Damn - unclestu 19:21:37 10/24/14 (3)
- breaks over - ringwear 19:54:21 10/24/14 (2)
- RE: breaks over - unclestu 14:23:22 10/25/14 (1)
- i see - ringwear 18:09:48 10/25/14 (0)