Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE:Thorens maintenance posted by eleiko2@verizon.net on October 15, 2014 at 03:36:11:
Hi
I have a TD160 Mk 2 of similar vintage as a back-up/project deck.
The principal maintenance tasks apart from belt replacement revolve around lubrication. The centre bearing should probably be cleaned out and re-filled with oil. Ordinary 3-in-1 is not suitable, BTW. The motor bearings (top and bottom) could probably also do with a drop of oil, though this can be a little more difficult to apply.
If the suspension still bounces well, it probably doesn't need adjusting, though this is the next stage in maintenance. My example came without an arm, so the suspension had to be set up when the chosen arm was fitted.
I obtained a maintenance kit from Joel Boutreux (ex-Thorens employee) via Ebay. His maintenance guide can be downloaded from Vinyl Engine, and offers much guidance.
HTH
Mark
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE:Thorens maintenance - markinuk 04:25:22 10/15/14 (4)
- RE:Thorens maintenance - eleiko2@verizon.net 07:39:39 10/15/14 (3)
- RE:Thorens maintenance - markinuk 08:43:48 10/15/14 (2)
- RE:Thorens maintenance - eleiko2@verizon.net 11:59:55 10/15/14 (1)
- RE:Thorens maintenance - dean man jim 15:46:28 10/15/14 (0)