|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Armless tables for a Jelco tonearm? posted by hesson11 on July 25, 2014 at 20:34:08:
You definitely DO want to use that arm. It is excellent.
Have you considered getting a platter bearing assy and motor / pulley assy from VPI and building a table. It's MUCH easier than people think. Build a base / plinth from laminated sheets of MDG or void-free birch plywood. 12" wide by 18" deep. Use a 1" to 1 1/2" think armboard that bolts to the corner of the plinth and gives enough rise to the arm and cartridge to match up with the top of the platter.
I did that with VPI TNT components with great results. And the arm was a SA-750D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Alternative - BPoletti 10:07:43 07/26/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
