Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Need Help With Benz Ruby Z Problem posted by steven d on July 18, 2014 at 19:32:40:
The right channel is recorded in the outer groove wall. If you have good tracking force and skating force much greater than anti-skating, the stylus may have insufficient force against the outer groove wall and this will cause mistracking in the right channel. You can increase the mass of the anti-skating weight by adding slotted washers on top of the existing weight.
Which Audiomods arm do you have? Can you post photos showing the arrangement of the anti-skating thread in its support? Also photos showing the counterweight assembly, at the Audiomods site it appears interesting. What shims and screws are you using with the counterweight?
A stylus can jump across the record if there is a lot of structure-borne feedback getting into the table and arm and you play at high volume. Does the jumping occur if you play at low volume, or no volume?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Need Help With Benz Ruby Z Problem - David Shreve 21:47:40 07/20/14 (1)
- Audiomods setup - steven d 10:04:41 07/21/14 (0)