I measured one I have here...

Posted by EdAInWestOC (A) on August 3, 2012 at 20:30:29

In Reply to: source for shell rubber washer? posted by michael22 on August 3, 2012 at 15:05:23:

Outer diameter - 0.46" (11.684mm)
Inner diameter - 0.31" (7.874mm)
Thickness - 0.025" (0.635mm)

You could always make one from gasket material. It will be tedious but its a solution.

NOTE: I measured the washer using a General Tools Dial Caliper. All measurements were repeated a few times to make sure I wasn't screwing up things. But I am good at that...

Ed
Life is analog...digital is just samples thereof

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - source for shell rubber washer? - michael22 15:05:23 08/03/12 (11)

RE: source for shell rubber washer? - WntrMute2 04:34:34 08/04/12 (0)

I measured one I have here... - EdAInWestOC 20:30:29 08/03/12 (0)

Get rid of the washer - unclestu 15:42:37 08/03/12 (7)

RE: Get rid of the washer - Lifer 21:29:36 08/03/12 (0)

Get rid of the washer?? - andyr 16:11:15 08/03/12 (5)

Examine the graham carefully - unclestu 16:17:53 08/03/12 (4)

Aah - understood. ... - andyr 16:54:02 08/03/12 (3)

RE: Aah - understood. ... - SgreenP@MSN.com 16:58:24 08/03/12 (2)

It's there to stop the cart turning as the bolts are tightened - rocky raccoon 02:41:01 08/04/12 (1)

RE: It's there to stop the cart turning as the bolts are tightened - andyr 02:46:11 08/04/12 (0)

RE: Mine dried up and cracked too! - amioutaline? 15:17:14 08/03/12 (0)

Follow Ups

I measured one I have here... - EdAInWestOC 20:30:29 08/03/12 (0)

I measured one I have here...

Post a Message!