|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: DIY interconnect with integrated passive filtering? posted by KanedaK on January 13, 2017 at 08:51:30:
It sounds to me like you are not setting up the crossover properly.
Rod Elliot has a good paper on setting up bi-amped systems. See link I attached. it's a two part paper.
It's not the power cord, or the OPAMPS, or the caps or the resistors. Fooling around with that will only make it worse.
At a minimum you need a calibrated sound level meter. That does not mean some IPhone app. Those mics are hardly flat. Ideally you would use a real time spectrum analyzer.
I run a tri-amped system and I have to tell you it's all about the calibration. You can't set up a crossover properly by ear.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- How are calibrating the system? - gusser 18:38:01 01/19/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
