Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tweakers' Asylum ]

---

[ Alert Moderator ]

---

RE: Xfinity X1 CATV box DC umbilical project

Posted by Sondek (A) on September 19, 2016 at 12:57:35

In Reply to: RE: Xfinity X1 CATV box DC umbilical project posted by Duster on September 18, 2016 at 14:56:25:

Duster,

Yes, a longer umbilical will be needed to accommodate my setup and allow for use of the KR PSU. Something in the 4' to 6' range, rather than the 18" one I have. The set-top box is the CISCO ISB7005. The wall wart that came with it outputs 12V 1.67A. The model number of the wall wart is ADS0202-U120167. I've not been able to find much past the install guide for the CISCO box, but a sticker on the bottom of it also specifics the same 12V 1.67A. I may go ahead and reconnect the KR just to further assess things, just that I will need longer cable to clean up the final appearance of the setup. Too many boxes and wires are ugly ... at least she says so.

Thanks

Mike

Edits: 09/19/16

This post is made possible by the generous support of people like you and our sponsors:

VH Audio

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---