|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: I just need a simple reliable. . posted by John PA on August 14, 2016 at 11:54:13:
the Surface mount IC's? There are other tools that need to be used to remove the surface mount IC's and other components. Metcal had tweezer like tools that would heat and grab the IC from both side at the same time. They would lift right up perfectly. They come in different sizes and work well.
Also there is a thing called Solder removal paste. You put it on all the leads and use the hot air blower for surface mount component removal. This would blow/move the solder away from all the leads and make the IC or other component ease to lift off without damaging the pads.
Once you have the proper tools, it is easy to remove surface mount components.
So you will need those other tools I have mentioned above along with the hot air warmer under the PCB's when doing the rework.
One other thing you must remember is that you must make sure all that desolder paste is totally cleaned off the board before trying to put on the new part. The desolder paste is conductive and with create a short if not cleaned off properly.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- What else are you using to help remove... - Cougar 10:44:44 08/15/16 (3)
- Thanks for the info. . . - John PA 13:12:40 08/15/16 (2)
- Which one? - Cougar 15:10:50 08/15/16 (1)
- I see one on Amazon and Ebay. .. - John PA 15:18:07 08/16/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
