Home Tweakers' Asylum

Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

Here's what I am wondering....

Is it possible that in your zeal to use the most robust possible parts, in terms of voltage and power ratings, that you've stuffed some physically over-sized parts into the chassis, especially capacitors, such that you then had to run much longer than original length leads from the new parts to the PCB or wherever they are supposed to connect? If so, this creates an antenna for RF, every time you do it. And hiss can result. I don't know who wrote that "hiss" is by definition a 3KHz noise (as you mentioned), but that is not far off the range where it might lie. You obviously cannot filter that out without losing a lot of music, which defeats your whole purpose in tweaking. I suggest you go back to the drawing board and take a look at whether you have some long leads in the circuit that are picking up stuff and amplifying it. And IF you still wish to install a filter, it had better be an RC type, not just a C, in this frequency range. Otherwise, your amplifier will be looking at a dead short at frequencies above cut-off. But fix the core problem is my recommendation. Then you won't need no stinkin' filter.


This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.