Home Tweakers' Asylum

Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

Mounting diodes

You cannot mount large two lead diodes like you would a tiny one that sits on a board. If your part is sitting in the air and resonating on its two leads....you will hear this. Very bad. You must damp all diodes, large transistors, regulators, heatsinks, etc. or you get bad sound. Use EAR SD40AL damping material (available from Percy Audio) along the top or sides of all diodes or from the top of the diode to another part. Then use a little Amazing Goop around the part of the damping material where it is touching the part as the glue on the EAR material is not very strong. Amazing difference for the better when your parts are not resonating. Check out my oppo 105 mod page for pics of damped diodes and parts. Don't put damping material directly on the face of anything electrical (including diodes). Damping material is not a good dielectric....damp along the edges only.


This post is made possible by the generous support of people like you and our sponsors:
  Michael Percy Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.