I saw the picture and thought - oh, no, a 3D printed rca plug

Posted by rickmcinnis@dogwoodfabrics.com (A) on December 12, 2014 at 09:00:32

In Reply to: Anyone use these? posted by Awe-d-o-file on December 11, 2014 at 08:21:54:

what a relief that it wasn't.

You should get rid of those miserable things.

Use XLRs without the body so you get something like the ultimate EICHMANN plug (and jack). Be sure to get silver plate.

Obviously, you only use two of the pins - you will need to come up with your own protocol. Assuming you are not a component of the week guy.

Next best thing to no jack at all.

And simplicity to clean.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Anyone use these? - Awe-d-o-file 08:21:54 12/11/14 (18)

Worthless, and dangerous... - Tympani 12:18:26 12/27/14 (0)

Worthless. - Rick W 12:15:13 12/13/14 (3)

RE: Worthless. - Awe-d-o-file 06:34:04 12/14/14 (2)

RE: Worthless. - Rick W 08:59:34 12/14/14 (1)

RE: Worthless. - Jack D II 13:36:19 12/18/14 (0)

I saw the picture and thought - oh, no, a 3D printed rca plug - rickmcinnis@dogwoodfabrics.com 09:00:32 12/12/14 (1)

RE: I saw the picture and thought - oh, no, a 3D printed rca plug - Awe-d-o-file 09:48:34 12/13/14 (0)

No. As an alternative... - R Browne 23:16:14 12/11/14 (4)

RE: No. As an alternative... - Awe-d-o-file 05:56:49 12/12/14 (0)

Good call. And another approach is....... - Winston Smith 23:33:00 12/11/14 (2)

RE: Good call. And another approach is....... - R Browne 23:46:46 12/11/14 (1)

Exactly. (Nt.) - Winston Smith 01:32:38 12/12/14 (0)

RE: Anyone use these? - cdb 15:05:15 12/11/14 (2)

Navcom rings - Jack G 07:56:07 12/13/14 (0)

RE: Yep - Cpk 05:41:55 12/12/14 (0)

RE: Anyone use these? - old guy 42 08:44:08 12/11/14 (2)

RE: Anyone use these? - Awe-d-o-file 10:03:22 12/11/14 (1)

RE: Anyone use these? - old guy 42 10:25:53 12/11/14 (0)

Follow Ups

I saw the picture and thought - oh, no, a 3D printed rca plug - rickmcinnis@dogwoodfabrics.com 09:00:32 12/12/14 (1)

RE: I saw the picture and thought - oh, no, a 3D printed rca plug - Awe-d-o-file 09:48:34 12/13/14 (0)

I saw the picture and thought - oh, no, a 3D printed rca plug

Post a Message!