Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: RE: Scott 222 d switch needed? posted by Dave Kost on April 9, 2016 at 19:03:16:
There are 222D photos in the thread linked below. Look at the back panel. There is an accessory (convenience) socket. Remove the rivets that hold that socket to the sheet metal. Clip and wire nut the leads to the socket's solder lugs. Use machine screws to hold a slide switch in the space made available.
AA sponsor Jim McShane may have the part you need.
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Scott 222 d switch needed? - Eli Duttman 19:26:56 04/09/16 (0)